Main Page Sitemap

Ice maker hookup valve


ice maker hookup valve

replacement Part Type, avg. Things You Will Need, drill, adjustable wrench 1/4-inch outside measure compression nuts -. Avoid using the bottom of the pipe, as this may draw sediment into the ice maker. Slide the compression nut and ferrule onto the tubing. Connect the ferrule and pressure nut to the hose at the refrigerator end. Drill holes through walls and/or floors as necessary.

Automatic ice makers need a simple hook-up to your cold water line. Store an additional 8 feet of tubing behind the refrigerator. Pail, warnings, make sure your refrigerator is disconnected before attaching the water supply line. Attach the valve to the pipe using two pipe clamps. Refine by, subscribe Save, subscribe Save Eligible, amazon Prime. Consult local plumbing codes to be sure what you do is permitted; for instance, saddle valves are not allowed by Massachusetts building codes. Plug in the refrigerator. Turn the water on to flush the tube into a pail for at looking for sex in Cairns least 1 quart or until the water runs clear. Take caution to not allow water to seep into your drill and make sure to only pierce one side of the pipe. An hour project of drilling and running flexible hose is well worth the pleasure of ice on demand. If applicable to your refrigerator, run the tubing through the hose clamp to hold it at the preferred angle. Avoid over-tightening; you can crush the copper pipe if you apply too much pressure.

Ok hookup
Crockpot hookup bed bath and beyond


Sitemap